|
|
Post by gaberlunzie on Jun 28, 2018 18:11:49 GMT
Hi. I want to make tokens for my cube, that fit into 63*44mm sleeves (half standard size, the same used in a lot of FFG board games). I'm trying to make a template for this, but can't seem to succeed. What I did:
Copied a folder of another template.
Made a new ccard.png of reduced size; instead of 523x375, it's 375x262. Link
Edited the style file, changing the values card width and card height to match the new image file.
The result is that MSE shows the card correctly of reduced size. However, it stretches the actual image file so that the image file is 523*375, and a lot of it is outside the card. Link
If I change the card size in the style file to 523x375, the whole frame image will be shown, but that will give bad results with font sizes, printing et cetera. I can change the image file to be 523x375 by adding a whole lot of empty space around it, but I worry that this will bring some unforeseen issues.
Obviously text alignment etc will be off, but that shouldn't be the cause of this, right?
This seems like it should be something obvious I'm missing, but googling didn't help much; most results where about how to properly export and print mse cards, rather than making cards of different sized design.
Thanks for any help.
EDIT: Nevermind, I was blind. Was under the #background stuff.
|
|
